Production of large batch preform machines

Since June 2003, Aoki Corporation has begun to demonstrate its SBIII-750LL-80S model at its factory. The demonstration bottle was a 17.6 g 500 ml water bottle and the molding time was only 9.6 seconds. Both preforms and finished bottles are molded at a rate of 6,000 bottles/hour, making them particularly suitable for mass production.

Achieving a production speed of 6,000 bottles/hour on a one-shot model not only reduces the unit cost but, more importantly, ensures that the number of moldings is the same to achieve the production target. Faced with fierce competition in terms of capacity, quality and price, manufacturers will focus on the ability to deliver quality products with consistent quality and quantity on time. In the short term, the unit-hour output is of course very important.

However, in the long term, we should focus on the ability to ensure consistent capacity and quality within one, two, five or even 10 years. In this way, it helps to establish user brands and increase profits.
The advantages of the SBIII-750LL-80S include:

* Increase production speed: synchronous movement of upper and lower molds; actuator for electric rotary table.
* Improve injection performance and shorten molding time: higher injection pressure and faster mold filling.
* Increased formability: The use of racks and racks to achieve simultaneous opening and closing of blow molding and closing devices (enhance high temperature and release properties, shorten drying cycle time); enhance the clamping force of each unit to accommodate high pressure blow molding .
* Improve maintainability: improve the mold structure, reduce the weight of the mold; use additional fixtures, easy to replace the mold.